Reflective White Fan-Panel Chest Harness with Underbust Band

This is a fan panel chest harness built from wide reflective white strapping that narrows into thin shoulder straps at the top and widens into a triangular panel across the chest before closing with a horizontal band under the bust. The reflective white finish carries a dotted texture that stays pale under normal room light and turns bright under a camera flash or headlights. The harness is cut in six labeled sizes from XS/S to 6XL/7XL, so the fan panel and the underbust band scale with the body instead of relying on one stretch fit.

Fan panel construction

The front panel is built as a single reflective piece that starts narrow at the base of the neck and fans out to roughly the width of the rib cage before it meets the underbust band. At its widest point above the underbust band, the panel measures close to the width of an average rib cage, roughly 24-30 cm depending on the labeled size. Two thin adjustable straps run over the shoulders and slide through keepers, so the top point of the fan panel can sit slightly higher or lower on the chest.

• Reflective white fan panel spanning the chest, widest at the underbust line
• Two adjustable shoulder straps with slide keepers, about 1 cm wide
• Horizontal underbust band that closes the bottom edge of the panel
• Dotted micro texture across the reflective surface, most visible under flash or headlights
• Trade-off: the reflective coating shows fingerprints and light scuffs faster than a matte harness

Styling the harness

Worn over a plain black bralette or bandeau, the fan panel becomes the only pattern in the outfit and the underbust band sits at the natural waist. Layered on top of a fitted black bodysuit and paired with high waisted trousers, the same underbust band lines up where a corset belt would normally sit, so the harness reads as an accessory rather than a base layer.

Sizing and fit range

The harness ships in six labeled sizes, XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL, and the shoulder strap keepers still leave room to adjust within a labeled size rather than across sizes. It fits torsos where the underbust band can sit flat against the ribs, and it does not work as a stand-alone top since the fan panel leaves both sides of the bust open.

• XS/S and S/M fit narrower rib cages, roughly 60-80 cm underbust
• L/XL suits a mid-range underbust measurement around 80-95 cm
• 2XL/3XL through 4XL/5XL extend the band for a 95-125 cm underbust range
• 6XL/7XL is cut for the largest underbust circumference in the line, above 125 cm
• The fan panel sits close to the ribs and will not layer well over a thick sweater

Faux leather and care

The straps and the fan panel are made from a coated faux leather that holds the reflective dot finish, and the strap keepers are the only moving hardware on the piece. Wipe the reflective surface with a damp cloth instead of running it through a washing machine, since heat and tumbling will crack the coating over repeated wears. Hand washing the plain strap edges in cold water is fine as long as the reflective panel itself avoids direct water pressure.