Full Body Harness with Choker, White Reflective Thigh Straps

This is a four-piece body harness that connects a fitted choker, a horizontal-bar chest panel, a separate waist belt and two adjustable thigh straps into one head-to-thigh accent piece. Every strap is cut from a smooth reflective faux-leather in white, so it reads as a soft off-white finish under normal room light and flares bright white under camera flash or headlights. Small square grommets run along each band and double as buckle adjustment points, letting each section tighten on its own. The overall silhouette is symmetrical, with matching straps on both legs and a centered chest panel, so the harness sits the same way whether viewed from the front or in profile.

Strap Layout & Hardware

The choker sits at the base of the neck and connects down through a chest panel built from three horizontal reflective bars, so coverage across the torso reads as a ladder rather than a single strap. A separate waist belt closes below the chest panel, and each leg carries a two-strap thigh piece that runs from the belt down to a horizontal band above the knee.

• Fitted choker collar with rear buckle closure
• Three-bar chest ladder panel connecting choker to waist
• Separate adjustable waist belt with square grommet trim
• Dual vertical straps per thigh joined by one horizontal band
• Matte nickel-tone metal buckles at every adjustment point

Styling & Occasion

Worn over a plain black bodysuit or a bralette-and-brief set, the white reflective straps sit as the only visible line against dark fabric, which is the combination this harness is built for. For a going-out look, layer it over a black slip dress and let the chest ladder panel and waist belt show through an open jacket; for a festival or night-run outfit, pair it with black leggings or bike shorts so the thigh straps catch light at knee height. Because the straps are reflective rather than glossy, they photograph brightest under flash or direct light and look more subdued in daylight. The waist belt also works layered over a fitted top rather than bare skin, giving the harness a second wear option beyond the head-to-thigh setup.

Sizing & Fit

This harness is sold in six labeled sizes, from XS/S up to 6XL/7XL: XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL. Each buckle adjusts within its labeled size, so XS/S and S/M suit slimmer frames while 2XL/3XL through 6XL/7XL extend the waist belt and thigh straps for fuller builds. The choker is a fixed loop with buckle adjustment, so anyone with a very short or very long neck should check the size chart before ordering, since the design is not meant to sit as a tight collar.

Material & Care

The straps and choker are made from a reflective faux-leather strip roughly 2.5 cm wide, backed with a soft finish so the buckle hardware does not dig against skin at the waist and chest lines. There is no separate lining fabric, since this is an open-strap design rather than a padded harness, and all hardware is a matte nickel-tone metal.

• Wipe the reflective strap surface with a damp cloth; do not machine wash
• Store flat or hanging to avoid creasing the reflective coating
• Keep away from direct high heat, which can dull the reflective finish
• Metal buckles may mark light fabrics if left in contact for long periods