Full Body Cage Harness with Rainbow Reflective Straps

This is a multi-strap cage harness made from rainbow reflective strapping that reflects camera flash and stage lighting back in shifting blue and purple tones. Two metal O-rings anchor the chest and waist sections, and the straps cross from the shoulders down into a geometric front pattern. It sits over a bra, bodysuit or bare skin and works best in low light or under camera flash, where the reflective effect is most visible. The design belongs to the reflective harness category rather than a plain leather harness, so the color shift is the main selling point.

Strap configuration and hardware

The front panel uses a series of straps that meet at a central O-ring below the chest, then branch out again toward a second O-ring at the natural waist. Small rivets hold each strap junction in place, and the shoulder straps run over the top of the shoulder rather than around the neck. The straps measure approximately 1.5 cm wide, which keeps the cage pattern visible without excess bulk. Because the straps are non-elastic strapping rather than stretch fabric, the geometric shape holds its form on the body instead of collapsing into loose lines.

• Two metal O-rings at chest and waist as the main hardware points
• Straps approximately 1.5 cm wide throughout the harness
• Rivet fastenings at each strap intersection
• Adjustable buckles on the shoulder and side straps

Styling and occasion

Worn over a black bodysuit, the harness reads as a going-out top for a club night or festival set, especially once stage lighting hits the reflective straps. Paired with a plain bra and high-waisted shorts, it works as a standalone rave outfit piece rather than a layering item, and the multi-strap front becomes the focal point instead of the bra underneath. It also photographs well over bare skin for a portrait session where the reflective straps are the main subject, since a plain dark background makes the color shift stand out more than a busy patterned outfit would. For a daytime festival look, a denim jacket left open over the harness keeps the straps visible while covering the shoulders.

Sizing and fit

The harness is offered in XS/S, S/M, L/XL, 2XL/3XL, 4XL/5XL and 6XL/7XL. The smaller sizes sit close to the body and suit a narrower rib cage and bust, while the largest size extends the strap length enough for a fuller bust and waist without the O-rings sitting too high on the chest. Because the straps form fixed cage sections rather than a single wrap-around band, sizing between the labeled ranges is not available, so buyers between two sizes should size up for comfortable movement and breathing room. Anyone with a narrow shoulder width may find the shoulder straps sit slightly wide even at the smallest size, since the strap spacing is fixed by the O-ring placement rather than adjustable side to side.

• XS/S and S/M for a close, snug cage fit
• L/XL for a mid-range torso and bust
• 2XL/3XL and 4XL/5XL for a fuller bust and rib cage
• 6XL/7XL for the largest listed size, with extended strap length

Material and care

The straps are made from reflective polyester webbing bonded to a thin reflective coating, with metal O-rings and rivets as the hardware. There is no separate lining since the straps sit directly against the skin or over another garment. Hand wash the straps in cold water, skip the dryer, and let them air dry flat so the reflective coating does not crack under heat. Direct ironing on the straps will damage the reflective layer, so keep an iron away from this piece entirely. With regular hand washing instead of a machine cycle, the reflective coating holds its color shift for repeated wear, though folding the straps sharply over time can leave faint crease lines in the coating.

• Reflective polyester webbing with a bonded coating
• Metal O-ring and rivet hardware
• Hand wash cold, air dry flat
• Keep away from direct heat and ironing